Insta Care Prime N Seal

Let your walls come alive with our colours.

INSTA CARE PRIME N SEAL

3 in 1 Water Proof. Primer. Sealer. For Interior & Exterior.

Apollo’s INSTA care prime & seal is modified acrylic water based alkali resistant primer with silicon additives. It resists surface alkality up to ph 12.0 and has been specially formulated for application on manufactured sand and fresh plaster. It resists dampness, efflorescence and provides excellent sealing property to the surface of application. It can be applied on interior and exterior cement plaster surface.

USP: Water proof, Seals surface, Efflorescence resistant, and silicon enriched.

Usage Area: It can be applied on Interior and Exterior cement plaster surfaces.

DIRECTIONS FOR USE:

Cleaning: Ensure that the surface to be painted is free from any loose paint, dust oil or grease. Any previous growth of algae, fungus or moss needs to be removed thoroughly by vigorous wire brushing and cleaning with water. If you use Apollo’s Cleanex, algae and fungus can be removed easily. Clean with water. Use our Bio- Wash for further protection from Algae.

Filling: a).For CRACKS: For filling cracks up to 3mm use Apollo’s INSTACARE CRACK LOCK. b).For HOLES & DENTS: In case of dents and holes use Apollo’s Wall grace putty or white cement and fine sand in the ratio 1:3.

Surface Application: Apply a coat of Apollo’s Instacare Prime –N- Seal by diluting it in one part of paint with one part of water. Allow it to dry for a minimum period of 4 hours before applying the subsequent coats of paint.

PRECAUTIONS:

 Do not apply when ambient temperature is less than 100C or if the temperature might drop to this level within 4 hrs of application.

 Do not over – thin or over – extend the brush.

 Stir well and strain before use.

 Keep the container tightly closed to prevent drying.

 Please keep out of reach of children and away from foodstuff.

 In case of contact with eyes, wash immediately with water and seek medical advice.

 Use 1 or 2 coats of Bio – Wash for killing fungal growth.

COVERAGE **

On Primed surfaceNo of CoatsCoverage
By Brush / Roller Application1 Coat100-120 sq ft / ltr

**It depends on many factors like surface conditions, surface preparation, application skill, weather conditions, dilution etc. The coverage mentioned is under ideal conditions and will vary depending on site conditions.

TECHNICAL DATA:

1ThinningPotable Water7Flash Point100% water – base paint, hence NA
2Thinning RatioMaximum of 1ltr of water per 1ltr of Paint.8Recommended
Surface
Interior or exterior concrete, masonry, plaster surfaces and brick work, fresh/green plaster and processed sand substrate etc.,
3Method of ApplicationBrush or Roller9CertificationAs per IS 109/1968
4Drying TimeSD : 30 minutes10Fire Hazard ClassNon - flammable
5Pot Life of Thinned MaterialUse within 24hrs11Safety DataRefer MSDS
6Gloss Level Matt Finish12VOC (gm/ltr)20gm /ltr

SPECIAL NOTE *

Before painting the following things should be checked thoroughly:

1. pH value of the wall surface (Ideal condition between 7-10).

2. Moisture content of the wall (Ideal condition –below 10-12%).

If these are violated, owner will be responsible.

*As per test conducted at Apollo R&D.

Menu